This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
docs:gsvit_inputs [2018/10/10 09:32] pgrolich |
docs:gsvit_inputs [2023/08/06 15:05] (current) pklapetek |
||
---|---|---|---|
Line 498: | Line 498: | ||
parameter "mode" is therefore followed by wavelength and by gaussian envelope width, | parameter "mode" is therefore followed by wavelength and by gaussian envelope width, | ||
given in integer steps of the simulation (e.g. 20), and finally electric field amplitude. | given in integer steps of the simulation (e.g. 20), and finally electric field amplitude. | ||
+ | </p> | ||
+ | |||
+ | |||
+ | <p><b>TSFF_EXPORT</b><br> | ||
+ | <i>filebase_e filebase_h</i><br> | ||
+ | Saves the calculated focused source boundary data for further use by SOURCE_TSFF_EXT. Only top z plane is used. Files contain both ex, ey and hx, hy components, for each step one file is created. | ||
+ | </p> | ||
+ | |||
+ | <p><b>SOURCE_TSFF_EXT</b><br> | ||
+ | <i>i_start j_start k_start i_end j_end k_end filebase_e filebase_h</i><br> | ||
+ | Uses pre-calculated focused source boundary data as a source. Only top z plane is used. Settings should be same as in SOURCE_TSFF_EXPORT. | ||
</p> | </p> | ||
Line 548: | Line 559: | ||
<p><b>OUT_IMAGE</b><br> | <p><b>OUT_IMAGE</b><br> | ||
- | <i>Ex/Ey/Ez/Hx/Hy/Hz/All/Epsilon/Sigma/Mu/Sigast nskip i j k description</i><br> | + | <i>Ex/Ey/Ez/Hx/Hy/Hz/All/Epsilon/Sigma/Mu/Sigast/Material nskip i j k description</i><br> |
Output image of plane cross-section. Which plane is used is determined | Output image of plane cross-section. Which plane is used is determined | ||
by indices i j k; two of them must be -1. All results are saved to a .gwy file, skipping given | by indices i j k; two of them must be -1. All results are saved to a .gwy file, skipping given |