User Tools
docs:gsvit_inputs
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
docs:gsvit_inputs [2019/03/18 17:07] pgrolich |
docs:gsvit_inputs [2023/08/06 15:05] (current) pklapetek |
||
|---|---|---|---|
| Line 498: | Line 498: | ||
| parameter "mode" is therefore followed by wavelength and by gaussian envelope width, | parameter "mode" is therefore followed by wavelength and by gaussian envelope width, | ||
| given in integer steps of the simulation (e.g. 20), and finally electric field amplitude. | given in integer steps of the simulation (e.g. 20), and finally electric field amplitude. | ||
| + | </p> | ||
| + | |||
| + | |||
| + | <p><b>TSFF_EXPORT</b><br> | ||
| + | <i>filebase_e filebase_h</i><br> | ||
| + | Saves the calculated focused source boundary data for further use by SOURCE_TSFF_EXT. Only top z plane is used. Files contain both ex, ey and hx, hy components, for each step one file is created. | ||
| + | </p> | ||
| + | |||
| + | <p><b>SOURCE_TSFF_EXT</b><br> | ||
| + | <i>i_start j_start k_start i_end j_end k_end filebase_e filebase_h</i><br> | ||
| + | Uses pre-calculated focused source boundary data as a source. Only top z plane is used. Settings should be same as in SOURCE_TSFF_EXPORT. | ||
| </p> | </p> | ||
docs/gsvit_inputs.1552925237.txt.gz ยท Last modified: 2019/03/18 17:07 by pgrolich
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial 4.0 International
