This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
start:first_simulation [2018/09/04 15:41] pgrolich |
start:first_simulation [2018/09/04 15:48] pgrolich |
||
---|---|---|---|
Line 43: | Line 43: | ||
Next we will add <b>point and image outputs</b>. This is done by menu entry //Edit parameters->Add point output// and //Edit parameters->Add image output// that again open dialogues for specifying how often (parameter "skip") and which component should be output. Point output is collected from a single point within computational volume and is stored into a text file. Image output comes to general output file that can be opened by [[http://gwyddion.net|Gwyddion]] open source software. A cross section in certain normal direction is output, selected as shown below. We will add a cross section in every direction, so we will call the dialog three times. | Next we will add <b>point and image outputs</b>. This is done by menu entry //Edit parameters->Add point output// and //Edit parameters->Add image output// that again open dialogues for specifying how often (parameter "skip") and which component should be output. Point output is collected from a single point within computational volume and is stored into a text file. Image output comes to general output file that can be opened by [[http://gwyddion.net|Gwyddion]] open source software. A cross section in certain normal direction is output, selected as shown below. We will add a cross section in every direction, so we will call the dialog three times. | ||
- | {{:start:first-simulation-image-output.png?400|}} | + | {{:start:screenshots:first-simulation-image-output.png?400|}} |
Similarily we will add **point output** as shown below. | Similarily we will add **point output** as shown below. |