User Tools
start:installation
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
start:installation [2018/10/12 15:16] rslesinger [Binary installation] |
start:installation [2018/10/12 15:17] rslesinger [Installing from source tarball] |
||
|---|---|---|---|
| Line 67: | Line 67: | ||
| == Gwyddion == | == Gwyddion == | ||
| - | You also need to have Gwyddion open source software installed to provide output to .gwy files. If you installed Gwyddion in a nonstandard location, you have to set up the //PKG_CONFIG_PATH// variable, e.g. by ''export PKG_CONFIG_PATH=/home/username/somedir/gwyddion-X.Y/lib/pkgconfig:$PKG_CONFIG_PATH''. | + | GSvit is also dependent on Gwyddion's libraries, so you need first to install this software. You can download and install it using procedures described on the official [[http://gwyddion.net/download.php|Gwyddion download]]. You also need to have Gwyddion open source software installed to provide output to .gwy files. |
| + | |||
| + | If you installed Gwyddion in a nonstandard location, you have to set up the //PKG_CONFIG_PATH// variable, e.g. by ''export PKG_CONFIG_PATH=/home/username/somedir/gwyddion-X.Y/lib/pkgconfig:$PKG_CONFIG_PATH''. | ||
| The software has primarily been tested on openSUSE, Fedora and Debian, but hopefully should run on any system with CUDA and Gwyddion. | The software has primarily been tested on openSUSE, Fedora and Debian, but hopefully should run on any system with CUDA and Gwyddion. | ||
start/installation.txt · Last modified: 2021/02/08 11:15 by pgrolich
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial 4.0 International
