User Tools
start:using_xsvit
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
start:using_xsvit [2018/01/29 12:18] pgrolich |
start:using_xsvit [2018/08/30 08:35] pklapetek |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== Using XSvit ===== | ===== Using XSvit ===== | ||
| - | **XSvit** is a graphical interface for **command line solver GSvit**. | + | **XSvit** is a graphical interface for **command line solver GSvit**. It serves as an editor of parameter files, where both parameters editing graphical user interface and direct editing of the parameter file are supported. XSvit can be used for creating or altering the parameter files, running the computational solver (GSvit) and running Gwyddion which serves as viewer of most of the results. |
| ===== Setting XSvit Preferences ===== | ===== Setting XSvit Preferences ===== | ||
| - | First of all set paths to **GSvit** and **Gwyddion**. You can view results in **Gwyddion**. | + | In order to run the calculation in XSvit, you should first set paths to **GSvit** and **Gwyddion**. This will be stored in your preferences settings and used for all the subsequent calls. |
| You can test it on this {{start:samples:xex18_1.par|parameter file}}. | You can test it on this {{start:samples:xex18_1.par|parameter file}}. | ||
start/using_xsvit.txt · Last modified: 2018/08/30 08:36 by pklapetek
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial 4.0 International
